I guess when you have 615 HP / 576 lb-ft Torque, even a factory 9" rear axle will pop on you (which it did)...

Micah at Hudlow Axle hooked me up with a beautiful set-up that is rated for 1000 HP + (http://www.hudlowaxle.com/).  They did a professional top notch job and even had it powder coated.  Once again I went to Chris Alston's Chassisworks / Total Control Products for a sweet looking FAB 9 housing.  I picked a 3.5 ratio.

Out of Car:

In Car and Ready to Roll:

Here are the components:
- Nodular 9 inch Cross Section (Was thinking about Aluminum, but they are only rated for up to 500HP)
- Billet Aluminum Pinion Support
- 1350 Forged Yoke
- Bearing Kit
- New Ring and Pinion (3.5 Ratio)
- 31 Spline Posi Race HD
- Setup Cross Section
- Fab 9 inch Housing
- Narrow Housing
- Install Spring Perches
- Good Used Housing Ends
- Custom Hudlow 31 Spline Axles Loaded with Bearings and Studs
- Solid Spacer

[ Home ]

Send mail to Phil@69MustangConvertible.com with questions or comments about this web site.
Copyright © 2008 1969 Ford Mustang Convertible
Last modified: 05/06/10